Directions For Use; Control Panel; Technical Data - Nedo ACCEPTOR 1 Manual De Instrucciones

Directions for Use

Control panel

"ON/OFF" button
1
Switches the receiver on and off
"Detector field resolution" button
2
Switches the resolution between rough and fine.
"Signal tone" button
3
Switches the signal tone between off/quiet/loud.
LCD display "Battery"
4
Comes on when the battery needs changing.
LCD display "Lower"
Comes on when the laser line is inside the sensor
5
window, but underneath the zero line. A slow tone
sequence also sounds.
6 Detector field
LCD display "Signal tone"
No display = signal tone off / flashing display =
7
signal tone quiet / steady display = signal tone
LCD display "Target"
Comes on when the laser line is precisely at the
8
level of the zero line. A continuous tone also
LCD display "Resolution fine"
9
Comes on when the resolution is set at "fine".
LCD display "Higher"
Comes on when the laser line is inside the sensor
10
window, but above the zero line. A rapid tone
sequence also sounds.
LCD display "Resolution rough"
11
Comes on when the resolution is set at "rough".
Loudspeaker for signal tone
12

Technical Data

Model
Order No.
Detector length
Resolution, rough/fine
Display
Power supply
Operating duration
Automatic switchoff
Attachment
Protection class
Dimensions
Weight
Suitable laser
Subject to technical modifications.
Operating instructions for laser receiver ACCEPTOR 1
loud
sounds.
Receiver ACCEPTOR 1
430325-613
40mm
switchable, ±3 mm / ±1.5 mm
LCD display on front/rear and signal tone (can be switched off)
Batteries: 1 x 9 V
up to 50 hrs
after about 10 mins.
M6 thread on the rear
IP65
W 79 mm / D 33 mm / H 150 mm
0.21 kg
Red laser diode with wavelength ~635nm
4
3
2
1
11
EN
5
6
7
8
9
10
12
3