A
B
C
D
E
F
Attaching the Cushion
Your mask may come with a Cradle Cushion in addition to the Pillows Cushion. Both
cushions attach to the mask the same way.
1. Look at the markings on the cushion to determine the correct placement of the cushion
onto the attachment hub (Figure 2). The arrows on the cushion and mask should be on
the inside (closer to your face).
2. To attach a cushion, place one of the cushion attachment holes
(Figure 3 A) over the appropriate post (Figure 3 C), pull the
cushion over the cushion attachment hub (Figure 3 B), and attach
the other side in the same manner. The cushion will stretch
without tearing.
3. To remove a cushion, simply peel it off of the cushion attachment
hub. For best results, grab the bottom of one side of the cushion
near the attachment post and pull the cushion over the hub.
Sizing the Pillows Cushion
The OptiLife Pillows Cushions are available in multiple sizes to
provide the most comfortable fit and to deliver the best therapy. To
determine which size to use, select a cushion that fills your nostrils
comfortably without any gaps between the cushion and the walls of
your nostrils.
1. Rotate the pillows cushion so it is at an angle (approximately 45°)
with the cushion attachment hub before inserting it into your nose
(Figure 4). For the Pillows Cushion, start in the back slot (Figure 4
B) and move to the front slot (Figure 4 A) if necessary.
2. Place the pillows cushion into your nostrils. Your chin should rest
comfortably in the support band (Figure 5).
Sizing the Cradle Cushion
The OptiLife Cradle Cushions are available in multiple sizes to
provide the most comfortable fit and to deliver the best therapy. In
most cases, the sizing of the Cradle Cushion matches the sizing of
G
H
Figure 1
A = Top Strap
B = Side Strap
C = Chin Support Band
D = Interface Tube
E = Swivel (Connects to
I
CPAP tubing)
F = Tube Management Clip
with Fabric Ring
G = Interface Frame and Hub
H = Exhalation Port (Do not block)
I = Cushion (Pillows shown)
M
Figure 2
A
B
C
Figure 3
A
B
Figure 4
3