Selector (Ref. To Fig. 1); Pushbuttons (Ref. To Fig. 1) - HUEGLI TECH HT DST4602 Manual De Uso

4.3

Selector (ref. to fig. 1)

Selector position
OFF/RESET
PROGRAM
MAN
AUTO
TEST
4.4

Pushbuttons (ref. to fig. 1)

Pushbuttons
SHIFT
LEFT/RIGHT
UP/DOWN
ENTER
6
User's Manual HT DST4602
Function
The generator is disabled; warnings and lockouts are cancelled.
You can program the parameters.
The Gen-set control module is set for manual gen-set control.
Press the START
Press the STOP button to stop the engine.
Buttons MCB and GCB
commutation/switches in accordance with system SW - HW configuration.
With BUS ON, synchronization is required. (see par. 5.1).
Gen-set is in automatic mode: all the functions are controlled automatically. The
ACK/TEST
combination of buttons
the TEST mode; the STOP
Buttons MCB and GCB
basis of the type and plant configuration). (see par. 5.1).
The activation of a suitably configured external input (or receiving a given command via
SMS or from a serial port) can force the starting of the generator and the load outlet with
the network connected or with the inhibition input on (REMOTE START).
Function
Dead key. If this is pressed with another button, it changes the button function. When
HELP is available on the page, holding this button down displays the HELP message on
the bottom status bar. LCD backlight ON. (see par. 3.5).
Horizontal scrolling buttons. These buttons let you select the previous or next page on
the display in all modes, except in the PROGRAM and HISTORY LOGS mode.
In PROGRAM mode, they are used to position the cursor when entering the strings.
Used in combination with the SHIFT
contrast.
To lower the contrast press the combination of buttons SHIFT
increase the contrast, press the combination of buttons SHIFT
(see par. 4.6.2).
Vertical scrolling buttons. These buttons let you select the multifunctional display mode.
In PROGRAM and HISTORY LOGS mode you can scroll the menus and the
variables/settings. You can increase/decrease the value of the variable to change the
settings. Used in combination with the SHIFT
menu ten entries at a time or increase/decrease the variables ten units at a time. During
the keyboard regulation phase you can increase or decrease the engine speed (if set to
synchronized) or the power supplied (if in power mode).
Lets you enter the PROGRAMMING mode and open submenus, change a variable, and
confirm the operation. Furthermore, you can enable the HISTORY LOGS function and
open the selected log, "acknowledge" any EEPROM errors at power-up, in the manual
synchronization and power setting phase, and enable keyboard regulation.
button to start the engine.
are for the manual control of the
and START
button lets you stop the gen-set (with a lockout).
let you switch devices (only inTESTmode and on the
button, they can be used to adjust the
lets you activate/deactivate
+ LEFT
+ RIGHT
button you can scroll through the
. To