Fuel Pump; Select Function; Fuel Pump Mode - HUEGLI TECH HT DST4602 Manual De Uso

5.4

Fuel pump

Gen-set implements the full management of the fuel pump, to pump fuel from the storage tank to the tank on
the generator. The pump can be managed automatically or manually using the controls on the front panel.
5.4.1

Select function

With the lockable selector in the MAN , AUTO or TEST position, select the E.XX"ENGINE MEASUREMENTS"
mode with the UP
RIGHT
setting procedure by pressing the ENTER
UP and DOWN

MANUAL-ON (pump on - the pump starts and will only stop when the max. fuel level is reached).

MANUAL-OFF (pump off)

AUTOMATIC (automatic pump - The pump starts and stops automatically, controlled by the
minimum and maximum level sensor).
Press ENTER
5.4.2

Fuel pump mode

With the lockable selector in position MAN , AUTO or TEST from any page or mode, you can open page "E.06
FUEL PUMP"" with the sequence of buttons SHIFT
Pressing the sequence of buttons SHIFT
command from:

MANUAL-ON (pump on - the pump starts and will only stop when the max. fuel level is reached).

MANUAL-OFF (pump off)
20
User's Manual HT DST4602
and DOWN
buttons until you reach page E.06 (FUEL PUMP). In this page you can start the standard
buttons to change the control mode. The following modes can be selected:
again to confirm the mode.
buttons. Scroll through the pages using the LEFT
button (operating mode highlighted in contrast), and use the
and EXIT
and EXIT again, you can change the fuel pump
.
or