Maintenance Kit Instructions - Weston HARVEST GUARD 65-1101-W Manual De Instrucciones

WARNING!
Vacuum Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS
REMOVED FROM THE OUTLET/POWER SOURCE!

MAINTENANCE KIT INSTRUCTIONS

Some parts of the Vacuum Sealer may need replacing after repeated use. The Vacuum
Sealer Maintenance Kit will be necessary for the Vacuum Sealer to properly function.
REPLACING THE OVAL VACUUM
CHAMBER SEALS:
1. Remove the Power Cord from the power supply.
2. Make sure the unit is completely cool.
3. Open the Vacuum Lid, press and unlock
both corners by pressing down on the two
grey corner panels on the Vacuum Lid.
4. Remove the Oval Chamber Seal from the
groove on the underside of the Vacuum Lid
(Figure 7).
5. Remove the Oval Chamber Seal from the
groove in the Vacuum Chamber.
6. Set a new Oval Chamber Seal from the
Maintenance Kit (Figure 8) on the groove in
the Vacuum Chamber. Work the seal into the
groove with your fingers until done.
7. Position a new Oval Chamber Seal into the
groove in the Vacuum Lid. Work the seal into
the groove with your fingers until done.
REPLACING THE SEAL BAR TAPE:
1. Remove the Power Cord from the power supply.
2. Make sure the unit is completely cool.
3. Open the Vacuum Lid, press and unlock both corners by pressing down on the
two grey corner panels on the Vacuum Lid.
4. Pick at either end of the Seal Bar
Element with a fingernail until it lifts slightly. Grasp the loose end and slowly pull
the Seal Bar Tape back over itself until fully removed (Figure 8).
5. Make sure that there is no residue or adhesive left on the Seal Bar Heating
Element or the machine. Use a dry paper towel to remove and excess residue.
6. Remove the backing from a new strip of Seal Bar Tape from the Maintenance
Kit (Figure 8). Be careful not to allow the Seal Bar Tape to contact anything
including itself while the adhesive side is exposed.
7. Hold one end of the Seal Bar Tape in each hand. Stick the left end of the Seal
Bar Tape to the flat area on the Vacuum Chamber just left of the Seal Bar Heating
Element. Apply the Seal Bar Tape from left to right over the Seal Bar Heating
Element until done. Make sure there are no wrinkles or folds in the Seal Bar Tape
once applied. The Seal Bar Tape should fully cover the Seal Bar Heating Element.
Before cleaning, assembling or disassembling the
-16-
Oval
Chamber
Seal
Seal Bar
Tape
Tape covering the Seal Bar Heating
Figure 7
Figure 8
Seal Bar
Tape
Oval
Chamber
Seals