Electrolux EWC 1050 Manual De Instrucciones página 18

18 electrolux
1. Spread some of the polystyrene pack-
aging materials on the floor behind the
machine and then lay the machine care-
fully rear side down on them. Make sure
that no hoses are crushed in the proc-
ess. Remove the polystyrene base from
the bottom of the appliance.
2. Return machine to it's upright position
and remove the power supply cable and
the draining and inlet hose from the
hose holders on the rear of the appli-
ance.
3. With a suitable spanner unscrew and re-
move the three screws and their
spacers on machine's rear.
4. The three holes must then be plugged
with the plastic plug caps supplied in
the bag containing the instruction book-
let, which can be found inside the drum.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or furniture. Level the wash-
ing machine by raising or lowering the two
front feet. If necessary, check the setting
with a spirit level. Any necessary adjustment
can be made with a spanner. Accurate lev-
elling prevents vibration, noise and dis-
placement of the machine during operation.