Electrolux EWC 1050 Manual De Instrucciones página 20

Ocultar thumbs Ver también para EWC 1050:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

20 electrolux
2. The machine end of the inlet hose can
be turned in any direction. Set the hose
correctly by loosening the ring nut. After
positioning the inlet hose, be sure to
tighten the ring nut again to prevent
leaks.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Important! Before connecting up the
machine to new pipework or to pipework
that has not been used for some time, run
off a reasonable amount of water to flush
out any debris that may have collected in
the pipes.
Water drainage
The end of the drain hose can be posi-
tioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
In this case, make sure the end cannot
come unhooked when the machine is emp-
tying. This could be done by tying it to the
tap with a piece of string or attaching it to
the wall.
In a sink drain pipe with a trap.
650-800 mm
The drain hose can be connected directly
into the pipe (e.g. beneath a washtub or
sink), above the water trap. The drain hose
must be arranged so that some part of it's
length is routed up to a level corresponding
to the top edge of the tub and fixed in place
there.
Directly into a drain pipe at a height of
not less than 65 cm and not more than 80
cm.
Their must be an air gap around and below
the end of drain hose. This means that the

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ewc 1350

Tabla de contenido