Instalación De La Interfase; Montaje Final; Inicializar La Interfase; Operación De La Pantalla Lcd - Metra 99-9700 Instrucciones De Instalación

Instalación de la interfase
With the key in the off position:
1. Connect the 99-9700 harness into the Axxess interface, and then to the wiring harness in the vehicle.
2. Connect the LCD screen into the Axxess interface.
Attention! To prevent error codes, all electronic devices including the headlight and turn signals must be connected
before proceeding to the next step.

Inicializar la interfase

Attention! If the interface loses power for any reason, the following steps will need to be performed again.
1. Turn the key to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position, disconnect the interface,
check all connections, reconnect the interface, and then try again.
2. Program the LCD screen:
a. Pull the screen protector from the LCD screen.
b. Press and hold the "Return/ESC" button on the LCD screen for 5 seconds until "Select Interface" comes up.
c. Select "Connection Type", and then press "Enter"
d. Scroll up or down to "Direct Connect", and then press "Enter"
e. Once done, press "Return/ESC" to back out of that mode.
3. Test the radio and LCD screen for proper operation. Refer to "LCD Operation" for further information.
4. If installing an ASWC-1/AXSWC (sold separately): After your radio and LCD are functioning correctly. Leave the
ignition on. Plug in the 1/8" jack into the back of your aftermarket radio. Then plug in the 12-pin pre-wired
connector into the ASWC-1/AXSWC, begin tapping the volume up button on the handle bar controls for 10
seconds. Your handle bar controls are now programmed. Having Trouble? Please download the ASWC-1/AXSWC
troubleshooting guide from the Axxess website.
5. Turn the key to the off position.
99-9700
1. Reassemble the fairing in reverse order of disassembly.
Operación de la pantalla LCD
* La pantalla LCD incluida proporciona el estado de la presión de aceite y
el EITMS.
Para más información, consulte el manual del propietario que se incluye
con la motocicleta.
Opciones del menú principal:
• Rojo ajusta el color rojo de retroiluminación de la pantalla LCD
(varía de 1 a 32).
• Azul ajusta el color azul de retroiluminación de la pantalla LCD
(varía de 1 a 32).
• Verde ajusta el color verde de retroiluminación de la pantalla LCD
(varía de 1 a 32).
• Contraste ajusta el contraste de la pantalla LCD (varía de 1 a 100).
• Restablecer regresa el color a los ajustes predeterminados.
Flecha arriba - Alterna hacia "arriba" entre las opciones del menú
Flecha abajo - Alterna hacia "abajo" entre las opciones del menú
Regresar/ESC - Regresa al menú anterior
Aceptar - Ingresa a la opción actual del menú
7

Montaje final