Kit Assembly - Metra 99-9700 Instrucciones De Instalación

1. Secure the radio brackets to the
radio housing with (4) #8 x 3/8"
Phillips screws supplied. (Figure A)
2. Remove the metal "DIN" sleeve and
trim ring from the aftermarket radio.
3. Slide the radio into the radio housing
assembly and secure with screws
supplied with the radio. (Figure B)
4. Insert the LCD screen into the radio
housing, route the cable through the
LCD back plate, and then secure to
the radio housing assembly using (2)
#8 x 3/8" screws supplied with the
kit. (Figure C)
5. Secure the radio housing assembly
to the bike using (4) 3/16 Allen
screws previously removed in step 8
of disassembly. (Figure D)
6. (a) For the Street Glide, Electra Glide,
Ultra, and Limited models 2014-Up;
Attach the radio bracket removed in
step 6 of disassembly to the top of the
radio housing assembly, and secure
with (4) #10-32 x 1/2" Phillips steel
machine screws supplied.

Kit Assembly

(Figure A)
(Figure B)
99-9700
(b) For the Road Glide
2015-Up; Attach the fairing
bracket removed in step 10
of disassembly to the top of
the radio housing assembly,
and secure with (4) #10-
32 x 1/2" Phillips steel
machine screws supplied.
Ensure the bracket is far
forward, and the curved
portion is facing the rear of
the bike as mentioned in
disassembly.
7. Locate the factory wiring
harness and antenna plug
in the dash. Refer to the
interface wiring instructions
on pages 6-8.
8. Reassemble the fairing in
reverse order of disassembly,
and then pull the screen
protector off from the LCD
screen.
5
(Figure C)
(Figure D)