Axxess Interface Installation; Connections To Be Made; Tools Required - Metra 99-9700 Instrucciones De Instalación

Axxess Interface Installation

FEATURES
• Provides accessory power (12-volt 10-amp)
• High level speaker input
• Retains balance and fade
• Retains oil pressure and EITMS status
• Prewired ASWC-1/AXSWC harness included (sold separately)
• Micro "B" USB updatable
INTERFACE COMPONENTS
• 99-9700 interface
• 99-9700 harness

TOOLS REQUIRED

• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
99-9700

Connections to be made

From the 99-9700 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Orange wire to the illumination wire. (If the aftermarket radio
has no illumination wire, tape off the Orange wire).
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output
From the 12-pin pre-wired ASWC-1/AXSWC harness to the aftermarket radio:
• This harness is to be used along with the optional ASWC-1/AXSWC (not included)
to retain handlebar controls. If the ASWC-1/AXSWC is not being used, disregard
this harness. If it will be used, please refer to the ASWC-1/AXSWC instructions
for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1/AXSWC
6