Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY and GENERAL INFORMATION
Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from manufacturer.
PRODUCT DESCRIPTION
This Hydraulic Service Jack is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads
must be supported by an identical pair of appropriately rated jack stands. This MagicLift™ service jack has a unique
feature that provides fast, no load lifts to the jacking point, at which time it lifts in approximately 3/4" ~ 2" increments.
!
WARNING: NEVER use hydraulic jack as stand-alone device. After lifting, immediately support the lifted
vehicle with an identical pair of appropriately rated jack stands.
SPECIFICATIONS
Model
Capacity
25057
25107
Jack Size (L x W x H)
5 Ton
54" x 18-3/8" x 7-1/4"
10 Ton
55-7/8" x 18-1/2" x 9-5/8"
handle
position
lock
foot pedal
castor
Figure 1 - Model 25057 & 25107 Components
Min. Height
handle
release valve
(handle knob)
handle sleeve
oil filler screw
(on reservoir)
2
Max. Height
6-1/2"
22-1/4"
6-7/8"
saddle
front wheel
27"
Publicidad
Tabla de contenido
