Safety And General Information; Product Description - Omega Lift Equipment MagicLift 25037 Manual De Instrucciones

SAFETY AND GENERAL INFORMATION

Save these instructions. For your safety, read, understand, and follow the information provided with and on this
device before using. The owner and/or operator shall have an understanding of the device, its operating characteristics
and safety operating instructions before operating the equipment. The owner and/or operator shall be aware that use
and repair of this product may require special skills and knowledge. Instructions and safety information shall be read
to and discussed with the operator in the operator's native language, making sure that the operator comprehends
their contents, before use of this equipment is authorized. If any doubt exists as to the safe and proper use of this
device, remove from service immediately.
Inspect before each use. Do not use if abnormal conditions such as cracked welds, damaged, loose or missing
parts are noted. Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall
be removed from service until repaired. If the equipment has been or is suspected to have been subjected to an
abnormal load or shock, immediately discontinue use until inspected by a factory authorized repair facility (contact
distributor or manufacturer for list of authorized repair facilities). It is recommended that an annual inspection be
made by an authorized repair facility. Labels and Operator's Manuals are available from the manufacturer.

PRODUCT DESCRIPTION

This Hydraulic Service Jack is designed to lift, but not support, one end of a vehicle. MagicLift™ service jacks have
a unique feature that provides fast, no load lifts to the jacking point, at which time it lifts in approximately 0.75~0.2"
increments.
!
WARNING: Do not use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle
with a pair of appropriately rated jack stands.
PREPARATION/ASSEMBLY
Before Use
1. Assemble the 2-piece handle with provided bolt.
2. Always secure the handle into the handle fork by means of the bolt and lock washer provided. Tighten securely
to prevent accidental removal of handle while in use.
! WARNING: Do not lift or carry jack by handle. Handle could dislodge and jack fall, resulting in possible injury
or property damage.
3. Before using this product, read the operator's manual
completely and familiarize yourself thoroughly with
the product and its components, and recognize the
hazards associated with its use.
4. Verify that the product and application are compatible.
5. To familiarize yourself with basic operation, locate and
turn the release valve (pump handle):
a. Clockwise until firm resistance is felt to further
turning. This is the 'CLOSED' release valve position
used to raise the saddle.
b. Counter-clockwise, but no more than 1/2 turn from
the closed position. This is the 'OPEN' release valve
position used to lower the saddle.
6. With saddle fully lowered and release valve closed,
pump the handle. If lift arm responds immediately,
jack is ready for use. If jack does not respond, follow
the Bleeding/Venting Trapped Air instructions on
page 3.
Handle
Oil Filler Plug
(release valve)
(ref. Parts illustration for location)
Handle
sleeve
Figure 1 - Typical Jack Nomenclature
2
Lift Arm
Saddle
Front Wheel
Caster