System Lay-Out; Technical Features - Allmatic PLUS Manual De Usuario

SYSTEM LAY-OUT

TECHNICAL FEATURES

PLUS is a series of linear irreversible operators, suitable for opening gates with a leaf
length of up to 5 metres (Fig.1).
The PLUS operators use mechanical stoppers, thus avoiding the need for electrical
limit switches.
On reaching the travel limit, the motor continues to operate for a few seconds, until
the timer of the control unit cuts in.
❷
❺ ❶
1 - PLUS operator
2 - Tuned aerial
3 - Flashing lamp
4 - Key selector
5 - Photoelectric cells (external)
61624021 rev. 00 01/03/2018
❶ ❺ ❹
883
368 58
815
TECHNICAL DATA
Max. leaf length
Max. leaf weight
Max. travel
Average opening time
Operating speed
EEC Power supply
Thrust force
❸
Motor capacity
Power absorbed
Capacitor
Power supply
Thrust force
❹
Motor capacity
Power absorbed
Capacitor
Power supply
Thrust force
Motor capacity
Power absorbed
Capacitor
Normative cycles 230V
Normative cycles 220V
Normative cycles 120V
Daily operations suggested
Service
1
Guaranteed consecutive cycles
Grease
Weight of electroreducer
Noise
Operating Temperature
Protection
* With incorporated mechanical stop that cuts in during opening. - If the mechanical stop is used
during closing (optional), the maximum travel is reduced by 40 mm.
Measurements in mm
15
PLUS PLUS L
m 4
kg 400
mm 368*
s. 20÷25 26÷33
m/s. 0,0125
230V~ 50Hz
N 2570
W 255
A 1,13
µF 6,3
220V~ 60Hz
N 2540
W 252
A 1,1
µF 6,3
120V~ 60Hz
N 2027
W 261
A 2,18
µF 25
n° 17 - 20s/2s 10 - 26s/2s
n° 19 - 20s/2s 10 - 26s/2s
n° 15 - 20s/2s 8 - 26s/2s
n° 150
60%
n° 30/19s 20/26s
Bechem - RHUS 550
kg 12,5 13,3
db <70
°C -10 ÷ +55
IP 44
1013
498
945
G
B
5
500
498*
58