Publicidad
Step 7
Carefully turn your unit over onto its front edges.
å
Fasten the BRACE (F) to the ENDS (A and B). Use four BLACK 9/16"
å
LARGE HEAD SCREWS (DD) through the ANGLE BRACKETS and into
the ENDS.
Fasten the BASE (G) to the ENDS (A and B). Use four BLACK 9/16"
å
LARGE HEAD SCREWS (DD) through the ANGLE BRACKETS and
into the ENDS.
Unfold the BACK (E) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (E). Push on
å
opposite corners of your unit if needed to make it "square".
Fasten the BACK (E) to your unit using the NAILS (FF).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF (D).
å
NOTE: Perforations have been provided for access through the BACK.
å
Carefully cut out the holes needed.
BLACK 9/16" LARGE HEAD SCREW
(8 used for the ANGLE BRACKETS)
www.sauder.com/services
These holes must line
up over the SHELF (D).
F
A
G
DD
Unfi nished edge
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
E
B
401290
FF
NAIL
(19 used for the BACK)
Page 11
Publicidad
