Sauder 401290 Manual Del Usaurio página 12

Step 8
1
D24
H
Groove
Insert the DRAWER SIDES (D24 and D25) at an angle
å
into the slot at each end of the DRAWER FRONT (H).
3
Fasten the DRAWER BACK (D65) to the DRAWER SIDES (D24 and D25).
å
Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D701) inserts into the groove of
å
the DRAWER BACK (D65).
Page 12
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D25
D65
D24
D701
VIEW THE T-LOCK BOX VIDEO
2
D24
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D701) into the grooves in the
å
DRAWER SIDES (D24 and D25) and DRAWER FRONT (H).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D25
401290
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
U n
fi n
s u i s h
r f a
e d
c e
D701
D25
H
30S
(4 used in this step)
www.sauder.com/services