Technical Specifications - King gates OVO Instrucciones Y Advertencias Para La Instalación Y El Uso

9.

Technical specifications

Nice S.p.a., in order to improve its products, reserves the right to modify their technical specifications at any time without prior notice. In any
case, the manufacturer guarantees their functionality and suitability for the intended purposes.
All the technical characteristics refer to a room temperature of 20°C (±5°C).
OVO technical specifications
Type
Pinion
Peak starting torque [corresponds to
the force necessary to keep set the
leaf in motion]
Nominal torque [corresponds to
the force necessary to keep a leaf
moving]
Speed under no load [corresponds if
"Fast" speed is programmed]
Nominal torque speed [corresponds
if "Fast" speed is programmed]
Maximum frequency of operating
cycles
Maximum continuous operating time
Operating limits
OVO power supply
Max. absorbed power
Insulation class
Emergency power supply
OVO courtesy light
Flashing Light Output
STOP Input
Step-by-step Input
Radio AERIAL Input
Radio receiver
Programmable functions
Recognition functions
Working temp.
Use in acid, saline or potentially
explosive atmosphere
Protection class
Dimensions and weight
Guide technical characteristics
Type
Guide length
Guide height
Useful stroke
Belt lenght
Belt height
Resistance to traction
Electromechanical gearmotor for the automatic movement of garage doors for residential use,
complete with electronic control unit
9.5 mm diameter, 28 teeth
9.9 Nm [550N]
4.95 Nm [275N]
103 rpm [0.14m/s]
The control unit enables 2 speeds equal to approx. 100% - 60% to be programmed
52 rpm [0.07m/s]
30 cycles per day (the control unit allows up to the maximum described in tables 2 and 3)
3 minutes (the control unit limits the continuous operation up to the maximum described in
tables 2 and 3)
In general, OVO is suitable for the automation of sectional or overhead doors which remain
within the dimensions stated in table 1 and limits specified in tables 2 and 3.
230Vac (±10%) 50/60Hz.
200 W
1 (a safety grounding system is required)
No
12 V-21 W
for 1 flashing light (12 V, 21 W)
For normally closed or normally open contacts or for constant resistance of 8.2 KΩ with self-
recognition (any variation from the memorised status causes the "STOP" command).
For normally open contacts (the closing of the contact causes the "STEP-BY-STEP"
command)
52Ω for RG58 or similar type of cable
Incorporated
6 ON-OFF functions and 6 adjustable functions (see tables 9, 10, 11 and 12)
Recognition of the type of "STOP" device (NO or NC contact or 8.2 KΩ resistance).
Recognition the door opening and closing positions and calculation of the slowdown and
partial opening points.
-20°C ÷ 50°C
No
IP 40 use only in indoor or protected environments
225 x 330 h 100 / 3.3 kg
GRO33
3-piece profile in galvanised steel
3.15 m
35 mm
2.6 m
6 m
6 mm
730 N
GRO13
single profile in galvanised steel
3.15 m
35 mm
2.6 m
6 m
6 mm
730 N
19