How To Use Nozzles - Generac G0065650 Manual Del Propietário

• NEVER connect high pressure hose to lance.
• Keep high pressure hose connected to pump and spray gun while
system is pressurized.
• Always be certain spray gun, nozzles and accessories are
correctly attached.
Figure 14 – Connect Hose to Spray Gun
6. Connect high pressure hose to pump (uncoil hose before
connecting to pump or spray gun) (Figure 15).
Figure 15 – Connect High Pressure Hose to Pump
7. Turn ON the water, squeeze the trigger to purge the pump
system of air (Figure 16).
Equipment damage. The hose can be damaged if it
comes in contact with the hot engine mu er. Keep
hose away from mu er during operation.
CAUTION
(000124)
Figure 16 – Squeeze Trigger

HOW TO USE NOZZLES

The quick–connect on the nozzle lance allows you to switch
between different nozzles. Nozzles can be changed while the
power washer is running, once the spray gun trigger is locked
in the safety position. The nozzles vary the pressure and spray
pattern as shown.
• For the most effective cleaning, keep the nozzle from 8 to 24
inches (20 to 61 cm) away from the surface being cleaned.
• If you get the nozzle too close, especially using a high pressure
nozzle, you may damage the surface being cleaned.
Fluid Injection. This machine produces high-
pressure uid streams that can pierce skin.
Fluid injection will result in death or serious
injury.
• NEVER exchange nozzles without the trigger lock being engaged on
the spray gun.
• DO NOT twist nozzles while spraying.
Follow these instructions to change nozzles:
1. Pull back the collar on the quick–connect and pull the current
nozzle off. Store nozzles in the accessory storage holder
(Figure 17).
Figure 17 – Nozzles
Set-up
DANGER
000123
(000106)
000125
9