Add Engine Oil - Generac G0065650 Manual Del Propietário

Set-up
Figure 4 – Insert Nozzles
5. Coil high pressure hose and hang on hook.
6. Attach siphon tube to location A (Figure 5).
Figure 5 – Siphon Tube Location
6
A

ADD ENGINE OIL

1. Place power washer on a flat, level surface.
2. Clean area around oil fill and remove orange oil fill cap/dipstick
(Figure 6).
Figure 6 – Fill Engine Oil
3. Using oil funnel (optional), slowly pour oil into oil fill opening.
See Maintenance section for oil type recommendation.
On some units there is more than one oil fill location. In these
instances it is only necessary to use one of the oil fill points.
4. Check periodically until the oil level is between "L" and "H" on
the dipstick (Figure 7). DO NOT OVERFILL.
Any attempt to crank or start the engine before it has been
properly serviced with the recommend oil may result in engine
failure.
5. Replace oil fill cap/dipstick and fully tighten.
Figure 7 – Dipstick
NOTE:
NOTE:
000115
000116