Emissions Information; Unpacking; Set-Up; Assembly - Generac G0065650 Manual Del Propietário

EMISSIONS INFORMATION

The U.S. Environmental Protection Agency (and California Air
Resource Board for equipment certified to CA standards) requires
that this engine comply with exhaust and evaporative emission
standards. Locate the emissions compliance decal on the engine
to determine what standards the engine meets, and to determine
which emissions warranty applies. The engine is certified to meet
the applicable emission standards on gasoline. It is important to
follow the maintenance specifications in the Maintenance section
to ensure that the engine complies with the applicable emission
standards for the duration of the product's life. This engine utilizes
lean carburetion settings and other systems to reduce emissions.
Tampering with or altering the emission control system may
increase emissions and may be a violation of Federal or California
Law. Acts that constitute tampering include but are not limited to:
• Removal or alteration of any part of the intake, fuel, or exhaust
systems
• Altering or defeating the governor linkage or speed-adjusting
mechanism to cause the engine to operate outside its design
parameters
If you are aware of any of the following symptoms, have your
engine inspected and repaired by your servicing dealer:
• Hard starting or stalling after starting
• Rough idle
• Misfiring or backfiring under load
• Afterburning (backfiring)
• Black exhaust smoke or high fuel consumption

UNPACKING

1. Remove the parts bag, accessories, and inserts included with
power washer.
2. Open carton completely by cutting each corner from top to
bottom.
3. Ensure you have all included items prior to assembly.
• Main Unit
• High Pressure Hose
• Siphon Hose & Filter
• Spray Gun
• Lance with Quick Connect Fitting
• Oil Bottle
• Parts Bag (which includes the following):
– Hose Hook Wireform with Screws and Allen Wrench
– Operator's Manual
– Owner's Registration Card
– Bag containing Color-coded Nozzles
– Filter Screen
4. If you are missing any items from your carton, please call
Generac Customer Service at 1-888-436-3722. When calling
for assistance, please have the model and serial number from
the data tag available.
5. Fill out and send in registration card. Write Model number,
Serial number & date of purchase in the table located in the
"Where to Find Us" section.

ASSEMBLY

WARNING
Consult Manual. Read and understand manual
completely before using machine. Failure to
completely understand manual and machine
could result in death or serious injury.
Read the entire operator's manual before you attempt to assemble,
or if you have any problems with the assembly of your power
washer, please call Generac Customer Service at 1-888-436-3722.
When calling for assistance, please have the model and serial
number from the data tag available.
1. The handle may be folded down or locked into position using
the integrated pull pin.
Figure 2 – Attach Handle
A
2. Install hose hook using provided screws and allen wrench
(Figure 3).
Figure 3 – Install Hose Hook
3. Insert color-coded nozzles in spaces provided in handle
(Figure 4).
4. Place spray gun and nozzle extension into spray gun holder as
shown (Figure 4).

Set-up

(000100)
5