Operation; Power Washer Location; Checklist Before Starting Engine; How To Start Your Power Washer - Generac G0065650 Manual Del Propietário

Operation

IMPORTANT: Spray gun traps high water pressure, even when the
engine is stopped and water is disconnected.
DANGER
Fluid Injection. This machine produces high-
pressure uid streams that can pierce skin.
Fluid injection will result in death or serious
injury.
• Keep the high pressure hose connected to the pump and spray
gun while the system is pressurized.
• ALWAYS point the spray gun in a safe direction, and squeeze the
spray gun trigger to release high pressure every time you stop
the engine. Engage the trigger lock when not in use.
OPERATION
If you have any problems operating your power washer, please call
Generac customer service at 1-888-436-3722.

POWER WASHER LOCATION

Clearances and Air Movement
DANGER
Asphyxiation. Running engines produce carbon
monoxide, a colorless, odorless, poisonous gas.
Carbon monoxide, if not avoided,
will result in death or serious injury.
For more information, reference the Carbon Monoxide
warnings in the Safety Rules section.
Place the power washer outdoors, in an area that will not
accumulate deadly exhaust gas. NEVER place the power washer
where exhaust gas could accumulate and enter inside, or be
drawn into a potentially occupied building. Ensure the exhaust
gas is kept away from any windows, doors, ventilation intakes,
or other openings that can allow the exhaust gas to collect in a
confined area. Prevailing winds and air currents should be taken
into consideration when positioning the power washer (Figure 23).
• Operate the power washer outdoors ONLY.
• Keep the exhaust gas from entering a confined area through
windows, doors, ventilation intakes, or other openings.
• NEVER start or run engine indoors, in a vehicle, or in an enclosed
area, EVEN IF windows and doors are open.
DANGER
Explosion and Fire. Fuel and vapors are extremely
ammable and explosive. Add fuel in a well
ventilated area. Keep re and spark away. Failure to
do so will result in death or serious injury.
• Keep at least 5 ft. (152 cm) clearance on all sides of the power
washer including overhead.
12
(000106)
(000103)
NOTE:
(000105)
Figure 23 – Building Clearances

CHECKLIST BEFORE STARTING ENGINE

1. Be sure to read and understand the Operator Safety section
and the Operation section before using the power washer.
2. Check that oil is at the proper level in the engine crankcase and
that fuel has been added to the fuel tank.
3. Review the unit's assembly and ensure the fittings are properly
secured. Also make sure there are no kinks, cuts, or damage
to high pressure hose.
4. Provide a proper water supply at an adequate flow, clear
screens of debris, and confirm that the system is purged of air.
5. Confirm that the unit is on secure, level ground and the
surrounding work area is clear.

HOW TO START YOUR POWER WASHER

DO NOT run the pump without the water supply connected and
turned on. Damage to the equipment resulting from failure to
follow these instructions will void warranty.
1. Move fuel valve (B) to ON (Figure 24).
2. Move choke lever (A) to CLOSE.
Figure 24 – Fuel Valve
NOTE:
000126
A
B
000127