Limited Warranty; Owner's Manual - Bowers & Wilkins CWM LCR8 Manual Del Usuario

English

Limited Warranty

Dear customer, welcome to B&W.
This product has been designed and
manufactured to the highest quality
standards. However, if something does go
wrong with this product, B&W
Loudspeakers and its national distributors
warrant free of charge labour (exclusion
may apply) and replacement parts in any
country served by an official B&W
distributor.
This limited warranty is valid for a period of
five years from the date of purchase or two
years for electronics including amplified
loudspeakers.
Terms and Conditions
1 The warranty is limited to the repair of
the equipment. Neither transportation,
nor any other costs, nor any risk for
removal, transportation and installation
of products is covered by this warranty.
2 This warranty is only valid for the
original owner. It is not transferable.
3 This warranty will not be applicable in
cases other than defects in materials
and/or workmanship at the time of
purchase and will not be applicable:
a. for damages caused by incorrect
installation, connection or packing,
b. for damages caused by any use other
than correct use described in the user
manual, negligence, modifications, or
use of parts that are not made or
authorised by B&W,
c. for damages caused by faulty or
unsuitable ancillary equipment,
d. for damages caused by accidents,
lightning, water, fire heat, war, public
disturbances or any other cause
beyond the reasonable control of B&W
and its appointed distributors,
e. for products whose serial number has
been altered, deleted, removed or
made illegible,
f. if repairs or modifications have been
executed by an unauthorised person.
4 This guarantee complements any
national/regional law obligations of
dealers or national distributors and
does not affect your statutory rights as
a customer.
How to claim repairs under
warranty
Should service be required, please follow
the following procedure:
1 If the equipment is being used in the
country of purchase, you should
contact the B&W authorised dealer
from whom the equipment was
purchased.
2 If the equipment is being used outside
the country of purchase, you should
contact B&W national distributor in the
country of residence who will advise
2
where the equipment can be serviced.
You can call B&W in the UK or visit our
web site to get the contact details of
your local distributor.
To validate your warranty, you will need to
produce this warranty booklet completed
and stamped by your dealer on the date of
purchase. Alternatively, you will need the
original sales invoice or other proof of
ownership and date of purchase.

Owner's manual

Introduction
Thank you for purchasing Bowers and
Wilkins CWM LCR8 speakers.
Since its foundation in 1966, the continuing
philosophy of B&W has been the quest for
perfect sound reproduction. Inspired by the
company's founder, the late John Bowers,
this quest has entailed not only high
investment in audio technology and
innovation but also an abiding appreciation
of music and movies to ensure that the
technology is put to maximum effect.
The CWM LCR8 is an audiophile quality in-
wall speaker that may be used in vertical or
horizontal orientation, the latter aesthetically
better for centre channel applications.
However, no matter how good the speakers
themselves, they will not deliver their full
potential unless properly installed. Please
read through this manual fully. It will help
you optimise the performance of the
system.
B&W distributes to over 60 countries
worldwide and maintains a network of
dedicated distributors who will be able to
help should you have any problems your
dealer cannot resolve.
Check the contents
The outer carton should contain:
In pack 1:
Wall frame,
Grille with fabric scrim backing,
Mounting template,
Paint mask.
In pack 2:
Baffle with drive units and crossover,
Fixing screws.
Choosing the position
Check that there is no conflict with other
installations (pipe work, air conditioning,
power cabling etc.). In existing drywall
construction, use a stud-finding tool to
map the construction accurately, and a
pipe detector to scan the proposed
installation position. Refer to the section
drawing of the speaker and ensure that
there is enough clearance behind the
plasterboard (sheetrock) for the clamps to
swing out fully. Avoid installing the speakers
in the same cavity as flimsy ducting, which
may be induced to rattle. The speakers are
designed to operate satisfactorily in a wide
range of cavity volumes, ideally above
20 litres (0.7 cu ft), so make sure the
volume is not too restricted by cross studs.
This is particularly important when the
speaker is installed in horizontal orientation
for centre channel applications. In order to
fit the speaker horizontally, part of one
vertical stud will have to be removed and
this will necessitate the use of two cross
studs to maintain the strength and integrity
of the wall.
In solid wall construction, be prepared to
provide a cavity in the wall that extends
outside the boundaries of the speaker's
frame, otherwise bass performance will be
compromised. The speakers are balanced
for half-space mounting (ie flush in a ceiling
or soffit). Placement near a wall/ceiling
junction or in a corner may give rise to too
much bass and a boomy quality to the
sound. Try to keep the speakers at least
0.5m (20in) from wall/ceiling edges. The
following sections give guidance on
optimum positioning, but this may be
modified in line with domestic constraints.
WARNING: The speakers produce a static
magnetic field. As such they should not
be placed within 0.5m (20in) of equipment
that may be affected by such a field
(eg Cathode Ray Tubes in TVs and
Personal Computers).
Front speakers for audio or home
theatre
Best imaging for 2-channel is obtained
when the speakers are mounted in the wall
in vertical orientation, with the tweeters
approximately at ear height and making an
angle between 40º and 60º at the centre of
the listening position. (figure 1)
For multi-channel home theatre the left and
right speakers should be approximately
0.5m (20 in) from the edges of the screen
and they and the centre speaker should be
as near the centre height of the screen as
possible. For a centre speaker, horizontal
orientation is normally preferred for
aesthetic reasons and you should choose
between above or below screen mounting
depending on which is nearer ear height.
(figure 2)
Surround speakers
The speakers should be positioned with the
tweeters 60cm (2 ft) or more above head
height.
5.1 Channel
The horizontal angle to the centre of the
listening position should be approximately
120º round from the centre of the screen.
(figure 3)
6.1 Channel Position
Two speakers to the sides in line with the
centre of the listening area and one
centrally behind the listeners (figure 4)
7.1 Channel Position
Two speakers to the sides in line with the
centre of the listening area and two behind
the listeners, subtending an angle of
approximately 40º. (figure 5)