Preparation; Before You Begin; Tools And Parts Needed; Parts Included - Siemens HB30S51UC Manual Del Usaurio

Preparation

Before you Begin

Tools and Parts Needed

Parts Included

30" Appliances

Dimensions for 30" Wall-Mounted Units
3/4"
29
(755mm)
29 1/16"
(738mm)
"
22 (559mm)
• Phillips head screwdriver
• Measuring tape
• Drill with bit (1/8")
• Phillips head screws (6)
"
24
(610mm)
28 1/4"
(718mm)
13/16"
27
(706mm)
27 "
(686mm)
min. 4
max. 31
23 7/8" (606mm)
28 1/2"
(724mm)
3/4" (121mm)
3/8" (797mm)
Single Oven 30"
It is good practice, when oven is
installed at the end of a cabinet run,
adjacent to a perpendicular wall or
cabinet door, to allow at least 1/4"
space between the side of the oven
and the wall/door.
For oven support, install 2x4's
extending front to back flush with the
bottom and the side of the opening.
The supporting base must be well
secured to the floor/cabinet and level.
Note: The conduit box must be
installed either above or below the
unit. If the conduit box is installed
below the unit, a 2" diameter hole or
space is required between the back
wall and the right rear of the 2x4
supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 190 lbs (86 kg).
English 3