Playing A Scene; Single Chase Mode; Mix Chase Mode; Playback Instructions - Chauvet Stage Designer 50 Instrucciones De Programacion

Stage Designer™ 50
Playing a
Scene
Manual Control
Audio Triggering
Show Mode
Beat Mode
Speed Modes
Single Chase
Mode
Mix Chase
Mode

Playback Instructions

To select a scene for playback:
Press <MODE SELECT> until the indicator LED (red) for Chase◄►Scene lights up.
1.
2. Press <PAGE> to select the page to which the desired scene is saved.
3. Push the MASTER fader B to its maximum position (fully down).
4. Set the SPEED and FADE faders to the desired positions
5. Move the desired scene's fader to maximum.
6. Adjust the total output level of the scene by moving the scene's fader.
Adjust the total output of all scenes with the MASTER fader B.
MASTER fader B controls the total output of the currently selected scene.
MASTER fader A controls the output of the physical faders 1 / 25 – 12 / 36.
For manual control during the playback of a scene:
1. Move MASTER fader A to the desired total output level.
2. Move faders 1 / 25 – 12 / 36 to desired positions.
NOTE: Faders will only override the recorded scene while new positions are higher than
recorded positions.
To enable audio triggering:
1. Press <AUDIO>. The indicator LED above it will light.
2. Use the AUDIO LEVEL fader to adjust the sensitivity.
To disable audio triggering:
Press <AUDIO> again. The indicator LED above it will turn off.
NOTE: Speed controls will not work if Audio Triggering is enabled.
To trigger steps manually during playback:
1. Move the SPEED fader to its lowest position, labelled SHOW MODE. The display will
read SPEED 29m07s12.
2. Tap <STEP> to trigger the next step.
NOTE: Show mode will only work with the SPEED fader at its lowest position. Any higher,
and the <STEP> button will have no effect.
To record a beat with the SPEED fader during playback:
1. Press <PARK> until the LED (yellow) indicating Mix Chase is lit.
2. Move the SPEED fader to the desired position.
3. Press and hold <REC SPEED>. Tap the flash button (<13 / 37> – <24 / 48>) of the desired
scene.
To disable a beat recorded this way, and return control to the SPEED fader:
1. Press <PARK> until the LED (yellow) indicating Mix Chase is lit.
2. Move the SPEED fader to its lowest position (SHOW MODE).
3. Press and hold <REC SPEED>. Tap the flash button of the desired scene.
To record a beat with the Tap Sync feature during playback:
1. Press <TAP SYNC>. Wait the desired time and press it again to set the beat.
2. Repeat as necessary
To disable Tap Sync, move the SPEED fader.
The SPEED fader has two modes, 5 min and 10 min. To switch between them:
Press and hold <RECORD>. Press <5> or <10> three times. Release <RECORD>.
The LED will indicate the current mode.
To operate in Single Chase mode (one scene, then the other) mode:
1. Press <PARK> until the LED (red) indicating Single Chase is lit.
2. Bring the fader or faders for the scene(s) you wish to cycle to the desired output level(s). The
Stage Designer™ 50 will cycle through them in order.
NOTE: Recorded beats/speeds will not work in this mode.
To layer scenes together, do the following:
1. Press <PARK> until the LED (yellow) indicating Mix Chase is lit.
2. Bring the fader or faders for the scene(s) you wish to play back simultaneously up to the
desired output level(s). Adjust the output of each scene as necessary.
NOTE: Manual cross-fading of scenes and recorded beats/speeds will only work in this mode.
2
EN