Chauvet Stage Designer 50 Instrucciones De Programacion página 3

Stage Designer™ 50
Auxiliary
Controls
Physical Fader
Assignment
Page Selection
Customization
There are 3 functions the auxiliary controls can serve:
1. FUNC 01: Disables the auxiliary knob and flash button.
2. FUNC 02: The auxiliary knob and flash button functions exactly as the original fader
and flash button did.
3. FUNC 03: The auxiliary knob sets the output value of the auxiliary flash button.
(Example: Set the knob to 255, and the channel will output 255 when the flash button is
pressed.)
To assign a channel and function to an Aux knob and flash button:
1. Press and hold <RECORD>.
2. For:
·
Aux 1: Tap <7> three times.
·
Aux 2: Tap <8> three times.
3. Release <RECORD>, then press and hold it again.
4. Tap one of the following flash buttons:
·
1 for FUNC 01.
·
2 for FUNC 02.
·
3 for FUNC 03.
5. Release <RECORD>, then tap the flash button (<1 / 36> – <24 / 48>) of the channel
you wish to assign.
Press and <RECORD>. Tap <REC EXIT>. Release <RECORD>.
·
FUNC 02: the original fader and flash button for the assigned channel will not
function.
·
FUNC 03: the original fader and flash button will still function, but the highest value
between them and the auxiliary will take precedent.
To alter the physical fader assignments:
1. Press and hold <RECORD>. Tap <6> three times. Release <RECORD>.
2. Press the flash button (<1 / 36> – <24 / 48>) of the DMX channel you wish to assign to
a different fader.
3. Press and hold <RECORD>. Press the flash button (<1 / 36> – <24 / 48>) of the fader
you wish to assign. Release <RECORD>.
4. Repeat steps 1–3 until the desired assignments are set.
Press and hold <RECORD> and tap <REC EXIT> to exit the mode.
All physical faders can be re-assigned to output on multiple DMX channels. There is no limit
to the amount of channels that can be assigned to a single fader. If desired, up to all 48
channels of DMX output can be assigned to a single fader.
The Stage Designer™ 50 has 24 faders, but 48 channels of DMX output. This works because
the channel outputs are split between two "Pages": Page A and Page B. Page A sets the
faders as channels 1–24. Page B sets the faders as channels 25–48. At startup, the product
will be set to the page that was set when it was powered down. The LCD display will show
which page is currently set.
To toggle between Page A and Page B:
Press and hold <RECORD>. Press <PAGE A_B>. Release <RECORD>.
3
EN