Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10. Raise the lever to eject the used capsule into the drawer and then close the lever
again (see figure 5).
NOTE: REMOvE THE USED CAPSULE RIGHT AFTER THE BREWING CyCLE
IS COMPLETE.
Q UA NT I T y OF C O FFE E
This espresso maker is set to prepare automatically 3 coffee selections, single shot,
double shot and lungo. If you wish to increase the quantity of coffee for any of these
three settings, please follow the instructions below:
1. Make sure unit has water in the tank.
2. Turn power switch on "I".
3. The three function buttons will start blinking simultaneously indicating that
the unit is warming up. Once the buttons light stay solid on, the unit is ready
to be used.
4. Raise the lever and insert the capsule, pressing it gently into place.
5. Close the lever firmly.
6. Adjust the position of drip tray grid and place the cup or mug under the
dispensing spout.
7. Press the desired coffee selection button and kEEP IT PRESSED DOWN.
8. Release the button when the desired amount of coffee is reached.
9. To re-program the button or program another button, repeat the steps above.
(Figure 5)
PE RS ONA L I ZI N G THE
E n g li s h - 7
Publicidad
Tabla de contenido
