Preliminary Settings - Sony UPA-P100MD Guia De Inicio Rapido

• If your computer is connected to a network, to be able
to make the preliminary settings of the UPA-
P100MD, it is necessary to isolate your computer
from the network so that the connection between the
UPA-P100MD and your computer is local.

Preliminary Settings

Before using the UPA-P100MD, you need to make
certain settings on your computer. Once you make
these settings, you can access the UPA-P100MD
Digital Capture Unit User's Guide and the device's
configuration screen. Use the following procedure to
make the preliminary settings.
Note
• Please use Windows computers to configure and
access the UPA-P100MD. Other operating
environments are not supported by the UPA-
P100MD.
• The procedures in this guide are based on Windows
98 dialog boxes and windows. Screen appearance
may differ slightly in other Windows versions.
1
Start the computer to which the Digital Capture
Unit is connected.
2
On the Start menu, point to [Settings], and then
click [Control Panel].
3
In [Control Panel], double-click [Network]. The
[Network] dialog box appears.
4
On the [Configuration] tab, click TCP/IP.
Note
If there is more than one TCP/IP entry in the
[Network] dialog box, make sure that you select
the TCP/IP that belongs to the network adapter.
5
With [TCP/IP] selected, click [Properties]. The
[TCP/IP Properties] dialog box appears.
6
Click the [IP Address] tab.
7
On the [IP Address] tab, click [Specify an IP
address].
8
In the [IP Address] box, type the following:
192.168.3.201
9
In the [Subnet Mask] box, type the following:
255.255.255.0
10
Click [OK]. The [TCP/IP Properties] dialog box
closes.
11
In the [Network] dialog box, click [OK].
12
Restart your computer.
5