Leveling/Shelf Installation - Steelcase TS Storage Nstrucciones De Instalacion

®
Lateral File & Open Shelf Lateral File Cabinet

Leveling/Shelf Installation

Access Open Shelf Lateral Leveling Glides
1.
Remove the adjustable shelf and clips.
2.
Remove the two (2) bottom screws on each side of the unit.
3.
Using tape attached to bottom pan, lift tape on bottom
pan to pull up for access to leveling glides. If there is not
tape already attached, use masking tape.
Remove the two (2) bottom
2
screws on each side so
bottom pan will clear when
lifted to access levelers
Open Shelf Lateral
Insert Shelf Clip and Install Shelf
To insert, angle down so top of clip goes in first.
Then squeeze and place into notch just below.
Make sure all four (4) clips are at same number of
notches high to ensure a level shelf.
1
Place back of shelf on notches first, then the front.
Space indicates
pan lifting
Pull Tape
and access
to lift pan
to levelers
underneath
Access Lateral File Leveling Glides
Remove bottom lateral file drawer (see page 2).
Level The Unit
Leveling of the cabinet is critical to ensure proper
!
function of the unit as well as maintaining and
protecting its aesthetics.
Adjust leveling glides while checking with level
both front-to-back and side-to-side.
Lateral
Page 11 of 57
P/N 939504734
Doc # 70305 Rev J