Caster Installation For Mobile File Center - Steelcase TS Storage Nstrucciones De Instalacion

®

Caster Installation for Mobile File Center

1.
Lay the unit on its back or top.
2.
Remove the caster kit from the drawer. The locking
casters go on the front.
3.
Position the caster plate over the smaller hole pattern.
4.
Install four (4) T20 torx drive pan head screws.
5.
Repeat steps 3 and 4 for the rest of the casters.
6.
Position outerhead wheel on outerhead;
align holes to wheel.
7.
Install outerhead wheel using two (2)
T20 torx drive pan head screws.
37mm (2 lock/ 2 non-lock)
OUTERHEAD WHEEL
LOCKING CASTERS
NON-LOCKING CASTERS
Insert Shelf Clip and Install Shelf
To insert, angle down so top of clip goes in first.
Then squeeze and place into notch just below.
Make sure all four (4) clips are at same number of
notches high to ensure a level shelf.
Place back of shelf on notches first, then the front.
Page 8 of 57
P/N 939504734
Doc # 70305 Rev J