Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USING YOUR DYSON MACHINE
PLEASE READ THE 'IMPORTANT SAFETY INSTRUCTIONS' IN YOUR
DYSON USER MANUAL BEFORE PROCEEDING.
LOOKING AFTER YOUR DYSON MACHINE
•
Do not carry out any maintenance or repair work other than that shown and
described in your Dyson User manual, or advised by the Dyson Helpline.
•
Always disconnect the plug from the mains outlet before inspecting for problems.
If the machine will not operate, first check that the mains outlet has an electricity
supply and that the plug is properly inserted into the outlet.
•
If the fuse needs replacing, please check 'User servicing instructions'.
OPERATION
•
Ensure that the machine is fully assembled in line with the instructions before use.
Do not dismantle the machine or use without the loop amplifier fitted.
•
The machine will not operate in heating mode unless the target temperature is
above the room temperature.
•
Each time heating mode is selected, it conducts a short calibration cycle. Airflow
will be automatically controlled during this cycle. Once the calibration cycle is
complete, it will revert to the selected airflow speed.
•
The machine will not oscillate when the control buttons are pressed.
•
Do not lubricate any part of this machine.
CONTROL WITHOUT REMOTE
•
Press the power button on the machine to turn on/off.
•
Press and hold the power button on the machine to adjust the target temperature.
The target temperature will increase to a maximum before decreasing. If the target
temperature is set at 0°C it will switch from heating to cooling mode.
•
The airflow, diffused and personal heating modes, oscillation function and sleep
timer controls cannot be operated without the remote control.
LED DISPLAY
•
The LED display will dim after 10 seconds of use.
•
Press any button, other than the Standby ON/OFF, to reactivate.
•
Do not press Standby ON/Off as this will turn the machine off.
SLEEP TIMER
To set the sleep timer, press and hold the Sleep timer button to select the desired
time. When time reaches zero, the machine will go into standby mode. To cancel,
reduce the time until two dashes appear.
•
The LED display will turn off after 10 seconds of inactivity - this is a power saving
feature and avoids light interference at night time.
•
Press any button, other than the Standby ON/OFF, to reactivate.
•
When sleep timer is ON, do not press the Standby ON/OFF as this will turn the
machine off and turn sleep timer off too.
TILT FUNCTION
•
Carefully hold the base and the main body. Tilt the loop amplifier forward or
backward for the required airflow angle.
AUTOMATIC CUT-OUT
•
For your safety, this machine is fitted with automatic cut-out switches that operate if
the machine tips over or overheats. If the switches operate, unplug the machine and
allow it to cool. Before restarting the machine, check and clear any blockages and
ensure that the machine is on a solid level surface.
•
In heating mode the machine will automatically switch off after 9 hours of
continuous use and will return to standby mode. To restart the machine, press the
power button on either the remote control or the base.
TROUBLESHOOTING
•
Fault codes F4, F5, F6: If one of these appears on the display, unplug the machine,
wait for 30 to 60 seconds and/or plug the machine into a different socket. If you
continue to receive the fault code, please contact the Dyson Helpline.
•
Fault codes F2, F3, F7: If one of these appears on the display, please contact the
Dyson Helpline.
REPLACEABLE PARTS
BATTERY REPLACEMENT
CAUTION
•
Switch off and unplug the machine before replacing the batteries.
•
Unscrew the battery compartment on the remote control. Loosen the base and pull
to remove the battery.
•
Do not install backwards or short circuit the batteries.
•
Do not attempt to dismantle or charge the batteries. Keep away from fire.
•
Always replace the screw in the remote control and refer to the battery hazard in the
warning section.
•
Follow battery manufacturers' instructions when installing new batteries (battery
type CR 2032).
•
Limited functionality is available without the remote control (see 'Control without
remote').
NON-WASHABLE FILTER UNIT
•
Your filter unit is non-washable and non-recyclable.
•
To replace your filter unit follow the steps as shown.
•
Failure to replace the filter when prompted may result in changes to product
performance and appearance.
•
A new filter unit can be purchased at www.dyson.com/filter.
14
DISPOSAL INFORMATION
•
Dyson products are made from high grade recyclable materials. Recycle
where possible.
•
Dispose of or recycle the battery in accordance with local ordinances
or regulations.
•
Keep the used batteries away from children as these can still harm children
if swallowed.
•
Your filter units are non-washable and non-recyclable.
•
Dispose of the exhausted filter units in accordance with local ordinances
or regulations.
•
The battery should be removed from the machine before disposal.
DYSON CUSTOMER CARE
THANK YOU FOR CHOOSING TO BUY A DYSON MACHINE.
After registering your 2 year warranty, your Dyson machine will be covered for
parts and labor (excluding filters) for 2 years from the date of purchase, subject to
the terms of the warranty. If you have any questions regarding your Dyson machine,
visit www.dyson.com.mx for online help, general tips and useful information
about Dyson.
Alternatively, you can contact us via email or phone with your serial number and
details of where and when you bought the machine.
If your Dyson machine needs a repair, email or phone Dyson so we can discuss
the available options. If your Dyson machine is under warranty, and it is a covered
repair, it will be repaired at no cost.
Your serial number can be found on your rating plate which is on the base of
your machine.
PLEASE REGISTER AS A DYSON MACHINE OWNER
To help us ensure that you receive a prompt and efficient service, please register as
a Dyson machine owner.
•
Online at www.dyson.com.mx/register
•
Register by phone: 01 800 872 0154
This will confirm ownership of your Dyson machine in the event of an insurance loss,
and enable us to contact you if necessary.
IMPORTANT DATA PROTECTION INFORMATION
WHEN REGISTERING YOUR DYSON MACHINE:
•
You will need to provide us with basic contact information to register your machine
and enable us to support your warranty.
•
When you register, you will have the opportunity to choose whether you would like
to receive communications from us. If you opt-in to communications from Dyson,
we will send you details of special offers and news of our latest innovations.
•
We never sell your information to third parties and only use information that you
share with us as defined by our privacy policies which are available on our website
at privacy.dyson.com
ELECTRICAL SPECIFICATIONS
127V~ 60Hz
1 600W
CONNECTION INSTRUCTIONS
•
Connect the plug on the power cord to a 127V AC power socket
•
Do not unplug by pulling on the cord, firmly grasp the plug and remove it gently.
•
Unplug the device from the AC power socket if you are not going to use the product
for an extended period.
Publicidad
Tabla de contenido
