General Characteristics - Astralpool 41636 Manual De Instalación Y Mantenimiento

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be implemented for installation
and start-up. Therefore, the installer as well as the user must read the instructions before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the led projector, follow the instructions indicated below:
1. VERIFY THE CONTENTS OF THE PACKING
The following accessories are included inside the box:
• Leds Projector
• Directional fastening system (2 sets)
• Installation and maintenance manual
THIS PRODUCT DOES NOT CONTAIN ANY ELEMENTS THAT CAN BE HANDLED, DISMANTLED OR REPLACED BY THE USER. IT IS FORBIDDEN
TO ACCESS INSIDE THE PRODUCT, OTHERWISE THE GUARANTEE OF THE PRODUCT WILL BECOME INVALID.

2. GENERAL CHARACTERISTICS

This projector is a Class III electric apparatus with very low safety voltage (12 V with alternating current).
The floodlamp compiles with IP67 degree of protection (No ingress of dust ; Ingress of water in harmful quantity shall not be possible when the
enclosure is immersed in water under defined conditions of pressure and time (up to 1 m of submersion). This projector compiles with international
safety standards for lights, especially the EN 60598-2-18 standard. LIGHTS PART 2: SPECIFIC REQUIREMENTS SECTION 18.
The mains supply to the light should have 30 mA overload protection. The power supply transformer of these projectors must be an insulated safety
transformer with separate spooling.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric components which have been inserted
or handled at locations other than its own premises.
3. INSTALLATION
Connection boxes should be at least 2 m. from the edge of the fountain or water installation.
The 230/12V transformer, which supplies the lamp, should be installed at a distance of 3.5 m. from the edge of the water installation.
The conduits installed less than 3.5 m. from the edge of the water installation, should not be lined or covered with metal.
4. ASSEMBLY
A. Ensure that the lamp is NOT receiving electrical voltage.
B. Insert the fastening brackets in the centre groove of the projector, tighten using an N3 Allen wrench.
C. Place the projector in position and use the 10 fastening drill holes as a template to mark the anchorage drill holes. The surface should be flat and
even.
Fastening System
Fig. 1
Ground
Fig. 3
Fig. 2
2