Broan B30 Serie Manual De Usuario página 4

NON-DUCTED INSTALLATION ONLY:
7
Remove Non Duct Diverter Covers held in place with
(4) Screws.
FRONT
SLOT
NON-DUCTED INSTALLATION ONLY:
8
Remove Metal Diverter from Front Slot and place into
Rear Slot.
NON-DUCTED INSTALLATION ONLY:
9
Replace Non Duct Diverter Covers.
10 NON-DUCTED INSTALLATION ONLY:
Purchase a set of (2) non-ducted filters (Model FILTER30)
from your local distributor or retailer. Attach the non-
ducted filters to the aluminum mesh filters following
instructions packed with the non-ducted filters.
FOR NON-DUCTED INSTALLATIONS - Skip to "INSTALL
THE HOOD".
NON DUCT
DIVERTER
COVERS
SCREWS
METAL
DIVERTER
REAR
SLOT
REAR
SLOT
MODELS B3030SS • B3036SS
3¼" X 10"
HORIZONTAL
KNOCKOUT
PLATE
DUCTED INSTALLATION ONLY:
11
Remove 3¼" x 10 vertical, 3¼" x 10" horizontal, or 7-inch
round knockout plate(s) as appropriate for your ducting
method.
NOTE: The knockout for horizontal ducting is slightly
smaller than the width of the 3¼" x 10" duct connector.
Align the duct connector with the hood centerline (± ½"),
NOT centered on the horizontal knockout opening.
Page 4
7" ROUND
KNOCKOUT
PLATE (also
remove 3¼" x 10"
vertical plate)
3¼" X 10"
VERTICAL
KNOCKOUT
PLATE