Install Filters - Best WM45I Manual De Usuario

9. Attach upper flue to plenum with (2) 3.9
x 9.5 mm pan head screws. Recirculation
slots should line up with plenum openings.
Fig. 21.
10. Install lower flue over upper flue. Tabs on
bottom of lower flue align and slide into
slots on top of hood.

INSTALL FILTERS

DUCTED AND NON-DUCTED HOODS
1. To remove the GREASE filter, push in latch
tab to disengage the filter from the hood.
Tilt the filter downward and remove. Fig.
22.
2. To install the GREASE filter, align rear filter
tabs with slots in the hood. Push latch tab
in, push filter into position and release.
Make sure the filter is securely engaged
after installation.
NOTE: Prior to use, remove protective film
from the filter frame.
NON-DUCTED HOODS ONLY
1. Purchase Filter Kit AFCWM45 from your
local dealer. This kit includes two filters and
wire retainers.
NOTE: Prior to use, remove protective film
from the filter frame.
2. Position one non-duct filter behind each
grease filter. Fig 23.
3. Fasten non-duct filter to back of grease
filter with wire retainers.
4. Re-install grease filter / non-duct filter
combination into hood.
3.9 x 9.5 mm
SCREWS
(2)
- 12 -
FIG. 21
FIG. 22
FIG. 23