Install Filters - Best P195ES70SB Manual De Instrucciones

Módulo de potencia
Ocultar thumbs Ver también para P195ES70SB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALL FILTERS

(NON-DUCTED HOODS ONLY) - Fig.8
1. Install a charcoal fi lter on each side of
the blower (included with Non-ducted
Charcoal Filter Model: ROUNDFILTER
2. To install the charcoal fi lter, align center
keyhole slot on the fi lter with center of the
blower. Rotate to lock fi lter into place.
3. To remove the charcoal fi lter, rotate the fi lter
until it disengages from the blower.
(DUCTED AND NON-DUCTED HOODS)
To remove the GREASE fi lter, grip the
latch tab and pull it down. This will dis-
engange the fi lter from the hood.
To install the GREASE fi lter, align fi lter tabs
to the side of the fi lter with slots in the
hood drawer. Pull latch tab down, push
fi lter up into place and release the tab.
• Make sure the fi lter is securely enganged
after assembly.
MAINTENANCE
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
Grease Filters
The grease fi lter should be cleaned fre-
quently. Use a warm detergent solution.
Grease fi lter is dishwasher safe.
To remove the grease fi lter: push in on the
metal latch tab. Tilt the fi lter downward and
remove.
Cleaning
Occasional care will help preserve its fi ne
appearance.
• Clean with warm water and mild detergent
only.
• Follow all cleaning by rinsing with clear water.
• Wipe dry with clean, soft cloth.
Light bulbs
This range hood requires two 13 watt G24q-1
Compact Fluorescent lamps (included). To
change bulbs (Fig.9):
1. Remove the frame by moving the 2 slide
fasteners (A) (Fig.4, page 6).
2. To replace lamp, grasp lamp at base and pull
out to remove. Replace with 13W Fluores-
cent lamp noted above.
CAUTION: BULB MAY BE HOT!
NON-DUCTED RECIRCULATION
OPERATION
Controls
The light switch turns the lamps on
and off.
The blower switch: makes it possible to
select the motor operating speed
speeds).
Position 0: motor off.
The pilot lamp lights up whenever the
blower is on.
LIGHT
SWITCH
0
1
PILOT LAMP
- 8 -
FILTERS
Fig.8
Fig.9
- Fig.10
(3
BLOWER
SWITCH
0
1
2
3
Fig.10

Publicidad

Tabla de contenido
loading

Tabla de contenido