INSTALLATION INSTRUCTIONS
POWER CORD AND STRAIN RELIEF INSTALLATION
Remove the wire cover on the lower back of the
range by removing its top center screw. Do not
discard this screw.
Remove the knockout ring located on the bracket
directly below the terminal block. To remove the
knockout, use a pair of pliers to bend the knockout
ring away from the bracket and twist until the ring is
removed.
For power cord installations
Assemble the strain relief in the hole of the bracket.
If tabs are present at the end of the winged strain
relief they can be removed for a better fi t.
Insert the power cord through the strain relief and
tighten. Allow enough slack to easily attach the cord
terminals to the terminal block.
Do not install the power cord without a strain relief.
The strain relief bracket should be installed before
reinstalling the rear range wiring cover.
1. Terminal block
2. Strain relief
3. Bracket
4. Power cord
2
1. Terminal block
2. Knockout ring in bracket
3. Knockout ring removed
For conduit installations
Purchase a squeeze connector matching the
diameter of your conduit and assemble it in the
hole of the bracket. Insert the conduit through the
squeeze connector and tighten. Allow enough slack
to easily attach the wires to the terminal block.
Do not install the conduit without a squeeze
connector. The squeeze connector should be
installed before reinstalling the rear range wiring
cover.
1. Terminal block
2. Squeeze connector
3. Bracket
4. Conduit
1
3
4
9
1
3
2
2
1
3
4