Troubleshooting - Danby DR202WGLP Manual Del Propietário

TROUBLESHOOTING

Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
PROBLEM
No power
Surface elements not working properly
Burners have yellow or yellow-tipped
fl ames
Burner fl ames very large or yellow
Strong odor
Surface burners light but oven does not
Oven light does not work
Danby Consumer Care: 1-800-263-2629
• A fuse may be blown or the circuit breaker tripped
• Plug not fully inserted into the wall outlet
• Burner holes on the side or around the top of the burner
may be clogged.
• Burners may not be fi tted correctly onto the mounting
brackets.
• The combustion quality of burner fl ames needs to be
determined visually. See the "Quality of fl ames" section of
the installation instructions for more information.
• LP gas is improperly connected.
• The thermostat capillary bulb must be clean and
unobstructed.
• The oven vent is blocked.
• Oven control improperly set.
• Improper size of cookware is being used.
• Improper air to gas ratio in the oven.
• An odor from the insulation around the oven liner is
normal the fi rst few times the oven is used.
• The oven gas shut off valve may have been accidentally
moved during cleaning or moving. Raise the cook top
and look for the gas shut off lever in the left rear corner.
Ensure the lever is in the open position.
• Light bulb is loose
• Light switch is not operating correctly
25
POSSIBLE CAUSE