Oven Light Replacement - Danby DR202WGLP Manual Del Propietário

Estufas de gas compactas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CARE & MAINTENANCE
Broiler pan and guard
After broiling, remove the broiler pan from the
oven. Remove the grid from the pan. Carefully pour
out grease from the pan into a proper container.
Wash and rinse the broiler pan and grid in hot
water with a soap-fi lled or plastic scouring pad.
If food has burned on, sprinkle the grid with
detergent while hot and cover with wet paper towels
or a dishcloth. Soaking the pan will remove burned
on foods.
Do not store a soiled broiler pan and grid anywhere
in the range.
Removable oven door
The oven door is removable but it is heavy. It
is recommended that at least two people work
together to remove it.
To remove the door:
1. Open the door to the full open position.
2. Pull the hinge locks up over the hinge hooks on
both sides.
3. Grasp the door fi rmly on both sides, lift slightly
and pull it straight out and away from the oven.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Insert and seat the upper and lower hinge arms
into the oven slots.
3. Push the hinge locks down from the hinge hooks.
4. Close the oven door and make sure it is working
properly. If it seems uneven or does not close
completely, remove it again and repeat the steps
to replace it.
Note: Do not attempt to close the door until it is
properly installed. The hinges could be damaged.
Glass door window
To clean the outside of the glass door window, use a
glass cleaner. Rinse and polish with a dry cloth.
Avoid scratching or impacting the glass window.
Doing so may cause the glass to break.

OVEN LIGHT REPLACEMENT

Important: Before replacing the oven light bulb,
make sure the electrical power is disconnected from
the appliance. Failure to do so may result in electric
shock or burn.
Be sure to let the light cover and bulb cool
completely before replacing.
Removing the oven door can make this process
easier.
To remove the light cover:
1. Twist the lens counterclockwise roughly 1/4 turn
to remove. Do not remove any screws to remove
the light cover.
2. Do not touch the light bulb with a wet cloth.
Replace the light bulb with a 40 watt appliance
light bulb.
To replace the light cover:
1. Line up the tabs of the lens with the tabs on the
light housing and rotate clockwise by roughly
1/4 turn to install.
24

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Dr202bglpDr202bssglp

Tabla de contenido