Remapping The Swc Buttons - Axxess CLASSII-100 Instrucciones De Instalación

Remapping the SWC buttons

Let's say you have the GMOS-100 programmed to your vehicle and your radio and you want
to change the button assignment for the steering wheel controls. For instance, if you would
like the "Seek Up" button to be assigned as "Mute".
Note, before beginning:
• The GMOS-100 must have detected the vehicle and radio it is attached to before
you can remap any buttons.
• You can only start the remapping of the steering wheel controls process after
20 seconds of turning the ignition key "On". If you wait longer than the 30 seconds
you will have to turn the ignition off then back on again.
• Within the first 20 seconds if any button other then "Volume Up" or "Volume Down"
is pushed, the remapping process will stop.
• If during the remapping process no button is pushed for 30 seconds the remapping
process is aborted and the original settings are reset.
Beginning the remapping process:
1.
Ideally having the GMOS-100 visible is recommended since you can see the
LED flashes to confirm button recognition.
2.
Turning off the radio is recommended.
3.
After seconds of turning the ignition "On" press and hold down the "Volume Up" button
for at least 25 seconds.
4.
The LED will light up solid red. Release "Volume Up" and the LED will go out.
"Volume Up" has now been programmed.
5.
Next, continue the process of remapping buttons to the SWC in order of the list below.
1
Volume Up
2 Volume Down
3
Seek Up/Next
4 Seek Down/Prev
5
Source/Mode
6
Mute
If you want to skip a command press the "Volume Up" on the steering wheel, this will
tell the GMOS-100 to skip the command and go to the next one.
CLASSII-100
7
Preset Up
8 Preset Down
9
Power
10 Band
11 Play/Enter
12 PTT (Push To Talk)
9
13 On Hook
14 Off Hook
15 Fan Up
16 Fan Down
17 Temp Up
18 Temp Down