Onstar Level Adjustment; Manually Setting Radio Type - Axxess CLASSII-100 Instrucciones De Instalación

OnStar Level Adjustment

To adjust the OnStar volume level find the Black/Yellow wire on the 16-pin harness.
•
Push the blue OnStar button, while the voice is speaking tap the Black/Yellow
•
wire to ground.
Once the volume is set it will stay at that volume until the Black/Yellow wire is
•
tapped to the ground again.
This can be set during installation and then left alone. If adjustment is desired, the
user may also tap "Volume Up" or "Down" on the steering wheel (if equipped) to
adjust the OnStar level.

Manually Setting Radio Type

If the LED flashes do not match the radio you have connected, you must manually program
the ASWC to tell it what radio it is connected to.
1. To manually program the aftermarket radio turn "On" the ignition. Then press and hold
the "Volume Down" button on the steering wheel control until the LED goes solid red and
then release the "Volume Up" button.
2. Using the listing below press the "Volume Up" button the number of times (number is
to the left of the radio name) needed to program the correct radio type:
3. Press and hold the "Volume Down" button for 5 seconds to finish programming. The
LED will then go off.
4. After a few seconds, the LED will then blink the number of times corresponding to the
radio type. This number should be the same number that the "Volume Up" button had
been pressed.
Continue on next page
CLASSII-100
1 Eclipse
2
Kenwood
3 Clarion "Type 1"
4
Sony/Dual
5
JVC
6 Jensen/Pioneer
7 Alpine
8
Visteon
9 Valor
10 Clarion "Type 2"
11 Metra OE
8