Installation; General; Opening The Device; Surveying The Connection Area - NEW ENERGY KACO blueplanet 87.0 TL3 Instrucciones De Operación

6

Installation

EN
6.1

General

Lethal voltages are still present in the connections and cables of the device even after the device has
been switched off and disconnected!
Severe injuries or death may occur if the cables and/or terminals/busbars in the device are touched.
6.2

Opening the device

↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
1 Undo the 6 screws and carefully remove the housing cover [ T_25]
2 Be careful not to damage or soil the seals or optical fibers when setting the
housing cover down.
» Proceed with the installation of the device.
6.3

Surveying the connection area

The connection point for the AC supply is situated inside the housing. The DC input source is also connected inside the
housing.
6
5
4
Fig. 12: Connection area on DC side (left) / AC side (right)
Legend
1 AC connection point
2 AC overvoltage protection base
3 AC earthing bolt
Page 16
DANGER
› The device must be mounted in a fixed position before being connected electrically.
› Observe all safety regulations and current technical connection specifications of the responsible power
supply company.
› The device may only be opened and serviced by an authorized electrician.
› Switch off the grid voltage by turning off the external circuit breakers.
› Do not touch the cables and/or terminals/busbars when switching the device on and off.
› Keep the device closed when it is in operation.
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
Fig. 11: Removing the housing
cover
1
2
1
2
3
4 DC connection point
5 DC overvoltage protection
6 PID connection point
KACO blueplanet 137 TL3 KACO blueplanaet 150 TL3
1
2
Housing cover
Screws for mounting