Configuring The Pv Generator; Connecting The Pv Generator - NEW ENERGY KACO blueplanet 87.0 TL3 Instrucciones De Operación

6.6.2 Configuring the PV generator

EN
Damage to components due to faulty configuration
In the expected temperature range of the PV generator the values for the no-load-voltage and the short
circuit current must never exceed the values for U
NOTE
Type and configuration of the PV modules.
Connected PV modules must be dimensioned for the DC system voltage in accordance with IEC 61730 Class
A, but at least for the value of the AC grid voltage

6.6.3 Connecting the PV generator

Risk of fatal injury due to electric shock!
Severe injuries or death will result if the live connections are touched. When there is solar radiation on the
PV generator, DC voltage will be present at the open ends of the DC cables.
Page 20
CAUTION
› Observe limit values in accordance with the technical data.
DANGER
› Activate the connection power at the switchbox or string combiner with the DC isolator switch.
› The DC connection is intended exclusively for PV generators. Other sources fall within the scope of im-
proper operation (e.g. batteries).
› Only touch the PV generator cables on the insulation. Do not touch the exposed ends of the cables.
› Avoid short circuits.
› Do not connect any strings with a ground fault to the device.
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
and I in accordance with the technical data.
DCMAX SCMAX
KACO blueplanet 137 TL3 KACO blueplanaet 150 TL3