Philips PR3723/00 Manual De Instrucciones página 5

6 If the lower back strap does not fit around your body, you can do the following.
1 Attach the extension strap to the Velcro strip on one end of the lower back strip (Fig. 6).
2 Then wrap the extended lower back strip around your body (Fig. 7).
3 Fasten the lower back strap with the Velcro strip at a width that feels comfortable (Fig. 8).
Positioning the upper back strap
1 To put the BlueTouch Pain Relief Patch in the upper back strap, follow the same procedure as
described in steps 1 and 2 in section 'Positioning the lower back strap' above.
2 Remove clothing from the area to be treated.
Note: Make sure the skin in the area to be treated is clean, entirely dry and free from creams,
lotions and other cosmetics.
3 Put on the upper back strap like a backpack. First, put one arm through the shoulder sling on
one side. Then do the same on the other side (Fig. 9).
Note: Make sure the BlueTouch Pain Relief Patch in the strap is located on the area to be treated and
the LED area is in contact with the skin.
4 Tighten the shoulder slings by pulling the elastic straps (Fig. 10).
Cleaning
Always remove the BlueTouch Pain Relief Patch from the strap before you put the strap in
the washing machine to clean it.
- The BlueTouch Pain Relief straps can be washed in the washing machine (Fig. 11).
Caution: To prevent damage to the BlueTouch Pain Relief straps, wash them in a fine-mesh
washing bag.
- Use a gentle cycle and a temperature of 30°C maximum. Dry the BlueTouch Pain Relief straps
on the air and not in the tumble dryer. Do not iron the straps.
Replacement
You can buy new straps from your dealer or in the online shop at
www.shop.philips.com/service.
Lower back straps
- PR3723: Lower back strap
Upper back straps
- PR3721: Upper back strap
ENGLISH
7