Installation Without Base - Chicco KeyFit 30 Manual De Instrucciones

INSTALLATION USING LATCH
Uninstalling Base
Remove.Carrier.from.Base
.Loosen LATCH.by.lifting.the.
1
LATCH.Release.Lever.and.pulling.
Base.away.from.vehicle.seat.back.
.Detach LATCH Connectors.
2
by.pressing.the.red.button.on.each.
LATCH.Connector,.and.remove.
Base.from.vehicle.
Storing LATCH
Insert LATCH Connectors into
storage pockets. .
a
.Pull LATCH Pull Strap.to.
1
secure.LATCH.Connectors.
.Roll LATCH Pull Strap.and.
2
store.in.Pull.Strap.Storage.Pocket.
NEVER travel with CHILD RESTRAINT unsecured in vehicle.
Passengers may be injured during a sudden stop or crash.
When not using LATCH, the LATCH Connectors and Pull Strap
MUST be stored properly.
1
2
1
.
a
2
36

INSTALLATION WITHOUT BASE

.Position Carrier.rear.facing.on.
1
vehicle.seat,.with.child.properly.
secured.in.Carrier.
.Route Vehicle Belt.under.
2
both.Belt.Guides,.and.buckle.the.
vehicle.belt.
.Tighten Vehicle Belt while.
3
pushing.Carrier.firmly.into
vehicle.seat..
A tightly rolled towel may be used
under the front edge of the Carrier if
needed for stable, secure installation.
.Check Installation:
4
.Level.Line.on.Carrier.MUST..
.
a
. . be.LEVEL.with.ground.
.
a
.Vehicle.belt.MUST.be.TIGHT..
.
b
.Carrier.MUST.be.STABLE
.
c
. . and.secure.
NEVER install CARRIER without Base using a non-locking
ELR vehicle belt. The installation will NOT be secure. Refer to
your vehicle owner's manual for detailed vehicle belt information.
2
3 4
b
.
a
37