Electrical Connection - Sencotel Granitore 1 Manual De Empleo

Note: Leave a 25 cm (10 inches) space in the upper part.
Fig. 5 shows the clearances required for access:
• the control panel on the right side;
• machine parts so that they may be serviced in the event of a fault.
After positioning the packing container in the vicinity of the installation site, pro-
ceed as follows:
1. cut the straps securing the box;
2. lift the cardboard box;
3. then lift the machine and position it on the prepared site.
Before the machine is used for the first time, its components must
undergo thorough cleaning and the parts that will come into con-
tact with the granita must be sanitized; for further details see the
relevant section herein.
5.3. Disposal of packing materials
After opening the box, make sure to separate the packing materials according
to type and dispose of them in accordance with the current regulations in the
user's country.
We recommend keeping the box for future conveyance or transport

5.4. Electrical connection

This job may be performed only by specialized technical per-
sonnel.
Before plugging in the machine, make sure that the main switch is on "0".
The Purchaser is responsible for making the electrical connection.
The machine must be connected to the electricity mains by means of the plug
fitted on the power cord. Be sure to comply with:
• the technical regulations and standards in force at the time of installation;
• the data shown on the rating plate on the side of the machine.
Warning: the electric outlet must be situated in a place easily
within reach of the user, so that no effort is required in order
to disconnect the machine from the power supply when neces-
sary.
If the power cord is damaged, you must have it replaced either by the
manufacturer or a specialized technician
It is forbidden:
• to use extension cords of any type;
• to replace the original plug;
• to use adaptors.
- 8 _EN-
6. OPERATION
Before the machine may be started up for the first time, specialized tech-
nical personnel must check that it functions properly.
6.1 Preparing the product
Warning: Product may be poured into the bowl only when the
machine is off and unplugged.
NEVER USE ONLY WATER
Fig.6
Dilute and mix the CONCENTRATE with WATER in a suitable container, follow-
ing the manufacturer's directions. THE MIXTURE OBTAINED MUST HAVE A
MINIMUM SUGAR CONTENT OF 13° BRIX - A lower concentration may dam-
age the augers and/or gearmotors.
To remove the lid from the bowl, follow these instructions:
1 lift the rear part of the lid;
2 extract the lid from the retainer placed in the front side.
Fig.7
Warning: do not force the lid opening in case of difficulty.
SL320005700 Ed.01 - 01-2014