Cleaning; Motor Housing; Shaft And Bell; Blade - Robot Coupe Mini MP 170 V.V. Manual De Instrucciones

W A R N I N G
Always unplug the power mixer before cleaning it!
Always dilute bleach according to the instructions on
the label.
Never run the power mixer through a dishwasher!
The type and concentration of the sanitation agent
must comply with 21 CFR 178.1010 regulations.
Clean according to local health department regu-
lations.

• MOTOR HOUSING

The power mixer must be clean through all stages
of production. Clean between each job using
a detergent or disinfectant. Dilute the detergent/
disinfectant following the instructions normally
specified on it's packaging container. Use a cloth
lightly dampened (not dripping) with the cleaning
solution. Do not allow liquid to come into contact
with the electrical components contained within
the housing. Be careful when cleaning around
vents do not allow liquid to drip or seep into
the housing. Use a cloth lightly dampened (not drip-
ping) with water to remove detergent/disinfectant
then dry using a clean cloth.
After using the power mixer in a hot mixture, cool
the bottom of the tube in cold water before disas-
sembling the bell from the shaft.
Clean immediately after use to prevent product from
sticking to surfaces.
8

CLEANING

Never immerse motor housing and/or handle in
liquid! The housing contains the electrical components
and is not sealed against liquid. Contact with liquid
can cause damage to the blender and serious injury to
the operator.

• SHAFT AND BELL

There are two ways to proceed:
Simple cleaning procedure
Submerge the shaft and bell in water and run for a
few seconds to clean. Unplug the power cord.
Complete cleaning procedure
Unplug the power mixer and rinse the bell under a
water tap. Remove the bell from the shaft, then
remove the blade (wear cutting gloves) ! Be careful
to avoid damaging the surface of the blade shaft
and the watertight seals. Always dilute the deter-
gent/disinfectant (see above). Thoroughly dry all
parts before reassembling.

• BLADE

The blade can be removed from the bell for
thorough cleaning. Always dry thoroughly to avoid
spotting.

• ALUMINUM

Use soft-metal-safe cleaning agents!

• PLASTIC

Be careful, many cleaning agents are corrosive
and are not safe for use on plastics !
Do not use strong alkaline detergent (having a
high concentration of soda or ammonia).
W A R N I N G

MAINTENANCE

• BLADE
Over time the blades will become worn and will
need to be replaced. The washer and seals should
also be replaced at this time. A blade service kit is
available.

• SHAFT SEAL

In order to maintain a watertight seal between the
shaft and bell, inspect the seal for wear and repla-
ce it if necessary.

TROUBLE SHOOTING

THE POWER MIXER DOES NOT START.
- Did you follow the previous operating instructions?
See section-Operating The Power Mixer.
- Pull the plug and try another outlet.
- Check outlet for current (breaker or fuse).
- Call local Robot Coupe authorized service agency.
THE POWER MIXER STOPS DURING (WHILE)
PROCESSING.
See the section on Operating the power Mixer. The
first paragraph describes the overload protection. It
may be necessary to allow the machine to cool for
up to 30 minutes before restarting.
If you cannot locate the cause of the problem
- Release the control button (CB).
- Unplug the power mixer.
- Are the blades free to rotate in the bell ?
- Is the drive shaft free to rotate ? To check this,
unplug the power mixer, remove the bell and test
the rotation of the end of the drive shaft manually.
Check the condition of the plug and the power cord.