Fcc Statement - BABYTREND AC01 A Serie Manual De Instrucciones

MAINTENANCE
DO NOT MACHINE WASH.
For metal and plastic parts,
use only lukewarm water
and mild soap.
SEAT FABRIC
7
• To remove the seat fabric for
maintenance, pull out all the
plates from the tab on the
seat base (Fig. 7a).
• To reattach the fabric, insert
the warning label side
towards the backrest of the
seat base. Fold the fabric
over and insert the rear
center plate into the tab.
Continue to connect all plates
around the seat base tabs.
All plates and tabs must be
secured before use (Fig. 7b).
TABLE LEGS
7
• To remove the legs from the
tabletop, press in the pin and
pull the leg out. Repeat for
the other 2 legs.
15
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 7a
Fig. 7b
Fig. 7

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interfer-
ence that may cause undesired operation.
WARNING:
this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful inter-
ference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Copyright © 2020, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
BABY TREND ®
Changes or modifications to
16