BABYTREND HC57 C Serie Manual De Instrucciones página 10

OPERATION
INFANT CAR SEAT
WARNING:
Avoid
serious injury from falling or
sliding out, always use the
Infant Car Seat harness.
•
ONLY approved SNAP TECH products can be
TM
used on the frame.
ADJUST FRAME HEIGHT
WARNING:
Do not adjust
car seat height with child in seat.
Adjust seat height before placing
your child in the car seat.
WARNING:
Always
check that the Height Adjustment
Bracket is level and both left and
right sides locked before placing
child in the car seat.
WARNING:
Never use
the car seat mode at any of the
higher positions. Always use the
car seat at the lowest position.
WARNING:
Never rest
the height adjustment bracket
on the locking pins.
23) • Squeeze both left and right Release
Handles of the Height Adjustment Bracket
and adjust to the lowest position (Fig. 23a).
DO NOT adjust with child in the seat.
ATTENTION:
The Height Adjustment Bracket must be set at the
lowest postion before placing car seat (Fig. 23b).
17
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Release Handle
Fig. 23a
Highest Position
Lowest Position
Locking Pin
Fig. 23b
TO ATTACH CAR SEAT
24) • Connect the Car Seat and lock into place
(Fig. 24a). Make sure its locked firmly in
place before use (Fig. 24b).
TO REMOVE CAR SEAT
25) • Detach Car Seat from Upper Frame
Assembly by pushing both modular
release buttons on each side of the seat
and lifting seat upwards (Fig. 25).
• ONLY approved SNAP TECH products can be
TM
used on the frame.
CAR SEAT MODE
Face in either direction,
front or backwards.
Infant car seat sold separately
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Fig. 24a
Fig. 24b
Fig. 25
18