Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Important Safety Information (Continued)
This compressor/pump is not equipped and should not be used "as is" to supply breathing quality air. For
any application of air for human consumption, the air compressor/pump will need to be fitted with suitable
in-line safety and alarm equipment. This additional equipment is necessary to properly filter and purify the
air to meet minimal specifications for Grade D breathing as described in Compressed Gas Association
Commodity Specification G 7.1, OSHA 29 CFR 1910. 134, and/or Canadian Standards Associations (CSA).
DISCLAIMER OF WARRANTIES
In the event the compressor is used for the purpose of breathing air application and proper in-line
safety and alarm equipment is not simultaneously used, existing warranties shall be voided, and the
manufacturer disclaims any liability whatsoever for any loss, personal injury or damage.
General Safety
•
Read all manuals included with this product carefully. Be thoroughly familiar with the controls and the proper
use of the equipment.
•
Follow all local electrical and safety codes as well as the United States National Electrical Codes (NEC) and
MANUAL
Occupational Safety and Health Act (OSHA).
•
Only persons well acquainted with these rules of safe operation should be allowed to use the compressor.
•
Keep visitors away and NEVER allow children in the work area.
•
Wear safety glasses and use hearing protection when operating the unit.
•
Do not stand on or use the unit as a handhold.
•
Before each use, inspect pump for signs of damage, deterioration, weakness or leakage. Repair or replace
defective items before using.
•
Check all fasteners at frequent intervals for proper tightness.
occur from contact with moving parts.
•
Do not wear loose clothing or jewelry that will get caught in the moving parts of the unit.
•
Keep fingers away from a running compressor; fast moving and hot parts will cause injury and/or burns.
•
If the equipment should start to vibrate abnormally, STOP the engine/motor and check immediately for the
cause. Vibration is generally an indication of trouble.
•
To reduce fire hazard, keep engine/motor exterior free of oil, solvent, or excessive grease.
in the air lines or in the tank for this compressor. The ASME safety valve must have sufficient flow and
pressure ratings to protect the pressurized components from bursting. The flow rating can be found
in the parts manual. The maximum safe pressure rating for the pump is 200 psi (two-stage) or 150 psi
(single stage). The safety valve in the intercooler does not provide system protection.
higher than 175 psi (two-stage) or 135 psi (single stage).
•
Fast moving air will stir up dust and debris which may be harmful. Release air slowly when draining moisture
or depressurizing the compressor system.
4 4
BREATHABLE AIR WARNING
Never operate compressor without a beltguard. This unit can
start automatically without warning. Personal injury or property damage could
Compressor parts may be hot even if the unit is stopped.
An ASME code safety relief valve with a setting no higher than 200 psi for
two-stage compressors or 150 psi for single stage compressors MUST be installed
Maximum operating pressure is 175 psi for two-stage compressors and 135 psi for
single stage compressors. Do not operate with pressure switch or pilot valves set
Publicidad
Tabla de contenido
