Rf Installation - Watts BT DPRF-01 Guía De Usuario

Then the message "Save" and blinking green LED
appears, press (OK) to validate the adjusted time
and date.
You can always reach the time and date
adjustments, by pressing and maintaining the
edition ( ) key during 2 seconds in normal
operating modes.
2.3

RF installation

- First of all to configure your thermostat with the
receiver, you must put your receiver in « RF init ».
mode. (please refer to the receiver leaflet for this,
only the RF receiver of the same range are
compatibles)
- Now on the thermostat press and maintain the
edition key ( ) during 10s, then the parameter «
ini » must be display.
14