Adjusting The Handle Height - Cosatto NITTY GRITTY Manual De Instrucciones

operation
(see illustrations further on in this booklet)
1 - list of parts
Your pushchair is supplied in one carton and contains:
1. Pushchair (basket attached)
2. Hoods
3. Footmuff x2
4. Raincover
Note: The style of the wheel may varies between models.
2 - opening the pushchair
To open the pushchair, first release the autolocks (a) one each side which hold the pushchair in the
umbrella position. Now holding the pushchair by its handles, gently lower the front. to complete
the operation: press down on both pedals (b), until you hear the 'click' from the secondary locking
bar (c).
WARNING: Ensure that all locking devices are engaged before use.
3 - using the brake
To apply the brake, press one of the brake levers down firmly with your toe (a). Test the brake is
engaged correctly by trying to push the pushchair forwards for a short distance. To release the
brake, lift any of the levers (b).
NOTE: Always apply brake before loading or unloading a child from the pushchair.
4 - using the front swivel wheels
To allow the front wheels to swivel, push down on the locking lever as shown (a). To lock the
wheels into position lift the locking lever up (b) with the wheels in any position and run the
pushchair until you hear each wheel 'click' as they lock in position.

5 - adjusting the handle height

To raise the handles press the buttons (a) on the inside of each upper hinge. The handles will
automatically spring to a higher position.
To lower the handles press the buttons again (b) then push the handles down (c). Release the
buttons but keep pressing down on the handles until they lock in place.
6 - using the harness
Five point harnesses are provided to restrain your children. To fasten a harness push clips into
buckle (a). To unfasten push the button in the centre of the buckle (b) and remove the clips.
Sliding adjusters are fitted on the waist strap and should be carefully adjusted so the harness fits
your child comfortably. To adjust to the smallest size you will need to thread the adjusters through
the "D" ring.
'D' rings are fitted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210.
The length of each strap can be changed by using adjusters (c), (d) & (e).
WARNING: Always use the crotch strap in combination with the waist belt
The harness can be removed for cleaning purposes. To remove the shoulder strap & crotch straps
push the plastic clips through from the rear of the seat unit (f) & (g). To remove the waist straps,
first unfasten the webbing by feeding the edge of the webbing through the opening of the metal
clip (h) and push the metal clips through from the rear of the seat unit.
To refit the harness reverse instruction above.
7 - fitting the softgoods
To fit the footmuff unfasten the harness and remove the chest pads and headhugger by unclipping
the shoulder straps from the buckle and sliding off the chest pads and headhugger (a).
5. Plastic drinks holder
6. Fabric bottle holder x2
7. Speaker
8. Changing bag (if specified)