Install Or Replace Equipment Parts En; Setting Up The Pneumatic Motor En - Binzel BRS-FP Instructivo De Servicio

6 Putting into operation
6.4 Install or replace equipment parts
NOTICE
• Disconnect the air supply and operating voltage.
 Fig. 4 Putting into operation on page EN-11
• Ensure that the covering hood (6) is attached again once installation is complete.
All installed equipment parts must have a diameter identification that is identical to the outer Ø of the gas
nozzle that is to be cleaned.
6.4.1 Setting up the pneumatic motor
1 Reamer holder
2 Gas nozzle
Fig. 9 Setting up the pneumatic motor
 Fig. 4 Putting into operation on page EN-11 and Fig. 9 Setting up the pneumatic motor on page EN-16
1 Loosen the compressed-air motor from the guide block (5) by removing the screws (3).
2 Pull back the pneumatic motor (4) in its mount.
3 Place the required distance sleeve (7) on the reamer (6).
4 Move the torch with the gas nozzle (2) to the clamping position (C).
5 Keep the guide block (5) in the lower position (down-stroke).
6 Place the pneumatic motor (4) against the gas nozzle (2) with the distance sleeve (7) placed on top.
7 Secure the adjusted motor position using the screws (3).
8 Move the torch out of the clamping device (1) and remove the distance sleeve (7) from the reamer (6).
EN - 16
1
7
6
5
4
3 Screws
4 Pneumatic motor
2
C
3
5 Guide block
6 Reamer
BRS-FP
7 Distance sleeve